Audi Technical Support
Solved technical support problems provided by FixYa users.

• audi a6 2.5 tdi 2001 model.i was stuck in trafic on my way home for a couple of minutes when the glow plug coil light on the dash board started flashing.when the trafic started moving again and i carr
  Check thefuses and wiring of the glow plug circuit.  check for corrosion on any of the contacts and while there, check each one with an ohm meter to make sure none have burned out. 
• how to remove front wheel bearing from audi a4 1.8
  take the hub off take to garage and get them to press out old bearing and get them to put new one in  
• Reset service engine light on 2010 mitsubishi lancer gts
  Need a scan tool to turn it off and you got to fix what ever is rong with it
• My 2001 Allroad wont start. The battery is good and it makes a clicking sound when I turn the ignition.
  You have a bad starter solenoid
• replacing a serpentine belt in 90audi quattro
  emove wheels and tires. Remove front part of fender liners. Remove 3 10mm nuts holding either end of the bumper onto the fenders, which can be seen when you pull the inner fender liners away. Remove air grilles around foglamps. Remove bumper bolts...
• 1 yr old battery. No power at all to car. Jumping
  Check and follow both the battery cable (positive and negative). May have a bad ground or connection in either cable. If they all check out then follow the positive to the main fuse and relay panel. Might have a burned wire or wires.
• getting codes P0341, p0300, p0301, p0302, p0303 on
  Hello! The Trouble codes are pointing at ONLY cylinders 1-2-and 3 (P0301, P0302, and P0303)...P0300 is telling you Random Misfires...P0341 is pointing at the Camshaft Positioning Sensor A (Bank One)...When you face the front of the engine, the Left...
• getting codes P0341, p0300, p0301, p0302, p0303
  P0300 is multiple misfire. The corrective action for this code would be to test your fuel pressure and the injectors. P0301, P0302, P0303 is saying in certain cylinders there is a misfire. There are two different engines so I wasn't sure which...
• 2001 A4 thermostat location
  Hello! Ignore my request regarding the engine size, The thermostat is well hidden..Standard labor to replace is 2.0 hours...Thermostat is part # 06B-121-111-G....Step 1: Drain coolant... Remove bottom belly pan... Remove coolant reservior tank...
• how to reset air bag light on audi 1999
  a B5. Look under the front of the seat - you'll see two harnesses there. The yellow one (closer to the center of the car) is the airbag connector. Zip-tie it tightly together, and then have the light turned off (find someone nearby with VagCom...
• how to reset the air bag light on audi 1999
  First of all you should access the Airbag ECU (Electronic Control Module) using suitable diagnostic equipment (VAS, VAG-COM) connected to the data link connector of the car in order to erase all faults - DTC's (Diagnostic Trouble Code) memored,...
• I have a red dash light lit. It is an exclamation
  ASR - Acceleration Skid Control system. When ASR warning light blinking the system is activated itself for car acceleration skid control. For today's typical high-torque engines, traction control (ASR) can increase both comfort and safety,...
• check engine epc code
  The EPC yellow light is not a DTC code! EPC means Electronic Pedal Control. First of all you need to access the Engine Control Module (ECM) using suitable diagnostic equipment connected to the data link connector of the car, in order to pull out all...
• cant find the clutch reservoir on my audi a4 1.8
  The Clutch Master Cylinder is located on the firewall inside the engine bay, and usually next to the brake master cylinder as the brake and clutch pedals are usually very close to one another. The Clutch Master Cylinder is responsible for...
• where do i add transmission fluid?
  The transmission fluid is checked and added (if necessary) through the transmission dipstick tube
• I recently had my 1998 a4 1.8t quattro in the shop
  Hello! You have a couple of options...# 1..It is important to maintaining the life of the car and also its resale value...I've included two diagrams of the turbo... The second of which is all off the vacuum lines....I do not know what the...
• audi q7 oil filter location
  The Audi Q7's filter is located in a housing on the drivers side of the engine, slightly above the Oil pan. To get to it, raise the Q7, and take off the plastic skid plate that runs along the transmission. Once that is off you will see the Oil...
• Oil filter location Audi Q7 3.6
  - When removing the plastic belly pans, don't assume all the fastener bolts are the same. They're all torx but there are actually three types...one type is obviously unique because it has grey bolt heads with washers. The other two...
• what does a warning symbol showing a circle w/an x
  Hi, I can help. On that year Audi (A6) the only two lights that would illuminate on your dash will either be for the brake light (top image in the diagram) or a headlight or tail light is out (bottom part of the diagram. So basically have a look...
• What grade of oil should
  1985 Audi 5000 S 2.2L MFI SOHC 5cyl;20W-50 Note : 4 1/2 Quarts without filter change
• I have an 1996 Audi a4 quattro, and just recently
  Try unlocking the car with the key on the passenger side and locking it again, that resets the alarm. Use the key to unlock the car, same problem on my Audi estate of the same age. Found out later one of the windows was still open and the sensor...
• Oil level and oil temperature are normal. Oil
  Same here....I soon had the same problem after changing the oil..Found out after many tests and research that auto parts stores cross reference a lot of audi oil filters to the vw counterparts..Which do fit audi,but are shorter and lack the oil...
• We have an audi a6
  You really need a dealer to reset the anti theft and key recognition.There are very few independent shop who can successfully do this . It does sound like you also might have drivers door micro switch fault...very common as the vehicle gets older ....
• i have audiA6 2001.when i was driving on highway
  First of all you need to access the Engine Control Module (ECM) using suitable diagnostic equipment connected to the data link connector of the car, in order to pull out all DTC's memored. DTC = Diagnostic Trouble Code. Then you will bu full...